Netgear GS752TS GS7xxTS-TPS Software Admin Manual - Page 75

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches SNMP From SNMP link under the System tab, you can configure SNMP settings for SNMPv1/v2 and SNMPv3. From the SNMP link, you can access the following pages: • SNMPv1/v2 on page 75 • Trap Flags on page 78 • SNMP v3 User Configuration on page 79 SNMPv1/v2 The pages under the SNMPv1/v2 menu allow you to configure SNMP community information, traps, and trap flags. Community Configuration To display this page, click System > SNMP > SNMP V1/V2 > Community Configuration. By default, two SNMP Communities exist: • Private, with Read/Write privileges and status set to Enable. • Public, with Read Only privileges and status set to Enable. These are well-known communities. Use this page to change the defaults or to add other communities. Only the communities that you define using this page will have access to the switch using the SNMPv1 and SNMPv2c protocols. Only those communities with read/write level access can be used to change the configuration using SNMP. Use this page when you are using the SNMPv1 and SNMPv2c protocol. 75