Netgear GS752TS GS7xxTS-TPS Software Admin Manual - Page 175

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches To configure the global ARP settings: 1. In the Age Time field, enter the value you want the switch to use for the ARP entry ageout time. You must enter a valid integer, which represents the number of seconds it will take for an ARP entry to age out. The range is 15 to 21600 seconds. The default value is 1200 seconds. 2. In the Response Time field, enter the value you want the switch to use for the ARP response timeout. You must enter a valid integer, which represents the number of seconds the switch will wait for a response to an ARP request. The range is 1 to 10 seconds. The default value is 1 second. 3. In the Retries field, enter an integer which specifies the maximum number of times an ARP request will be retried. The range for this field is 0 to 10. The default value is 4. 4. In the Cache Size field, enter an integer which specifies the maximum number of entries for the ARP cache. The range is 79 to 1024. The default value is 1024. 5. In the Dynamic Renew field, select whether the ARP component automatically attempts to renew ARP entries of type Dynamic when they age out. The default setting is Enable. 6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. 7. If you change any of the settings on the page, click Apply to send the updated configuration to the switch. Configuration changes take effect immediately ARP Entry Management Use this page to remove certain entries from the ARP Table. To display the page, click Routing  ARP, then click the Advanced  ARP Entry Management link. 175