Netgear GS752TS GS7xxTS-TPS Software Admin Manual - Page 216

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches To configure an Access Profile: 1. In the Access Profile Name field, specify the name of the access profile to be added. The maximum length is 32 characters. 2. To activate an access profile, select the Activate Profile check box. You cannot add rules to an active profile. 3. To deactivate an access profile, select the Deactivate Profile check box. 4. To remove an access profile, select the Remove Profile check box. The access profile should be deactivated before removing the access profile. 5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. 6. If you make changes to the page, click Apply to apply the changes to the system. The Profile Summary table shows the rules that are configured for the profile, as the following table describes. Field Rule Type Service Type Source IP Address Mask Priority Description Identifies the action the rule takes, which is either Permit or Deny. Displays the type of service to allow or prohibit from accessing the switch management interface: • SNMP • HTTP • HTTPS Displays the IP Address of the client that may or may not originate management traffic. Displays the subnet mask associated with the IP address. Displays the priority of the rule. The rules are validated against the incoming management request in the ascending order of their priorities. If a rule matches, action is performed and subsequent rules below are ignored. Click Refresh to update the page with the most current information. 216