Netgear GS752TS GS7xxTS-TPS Software Admin Manual - Page 294
Traceroute, IPv6 Address/Host Name, Datagram Size, Result, Cancel, Apply, Count, Maintenance
View all Netgear GS752TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 294 highlights
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches To configure the settings and ping a host on the network: 1. In the Ping field, select either Global or Link Global to select either the global IPv6 Address/Hostname or Link Local Address to ping. 2. Optionally, configure the following settings: • In the IPv6 Address/Host Name field, enter the IPv6 address or Hostname of the station you want the switch to ping. The initial value is blank. The IPv6 Address or Hostname you enter is not retained across a power cycle. • In the Datagram Size field, specify the size of the datagram to send. The valid range is 48-2048. • The Result field displays the result after the switch send a Ping IPv6 request to the specified IPv6 address. 3. Click Cancel to cancel the operation on the screen and reset the data on the screen to the latest value of the switch. 4. Click Apply to send the ping. The switch sends the number of pings specified in the Count field, and the results are displayed below the configurable data in the Result area. • If successful, the output will be Send count=3, Receive count = n from (IPv6 Address).Average round trip time = n ms. • If a reply to the ping is not received, the following displays: "Reply From IP/Host: Destination Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec". Traceroute Use the Traceroute utility to discover the paths that a packet takes to a remote destination. To display this page, click Maintenance > Troubleshooting > Traceroute. 294