Dell 5130 Color Laser User's Guide (PDF) - Page 137
Copy Printer Settings
View all Dell 5130 Color Laser manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Remote peers IPv6 address Specifies the IP address to connect to. Non IPsec communication policy Selects whether or not to communicate with a device which does not support IPsec. *1 This item is effective only when the optional hard disk is installed and is set to On for encryption. NOTE: If IPsec is enabled with incorrect settings, you must disable it using the Reset IPsec menu on the operator panel. 802.1x Purpose: To specify the settings for IEEE 802.1x authentication for encrypted communication to the printer. Values: Enable IEEE 802.1x Select the check box to enable IEEE 802.1x authentication. EAP-MD5 Authentication Method EAP-MS-CHAPv2 PEAP/MSCHAPv2 Select the authentication method to use for IEEE 802.1x authentication. Login Name: (Device Name) Specifies the login name (device name) for IEEE 802.1x authentication using up to 128 alphanumeric characters. Password Specifies the login password for IEEE 802.1x authentication using up to 128 alphanumeric characters. Re-enter Password Enter the login password again to confirm it. IP Filter Purpose: To specify the IP address and subnet mask to be permitted or denied access to the printer. Values: Address Address Mask Active Mode Specifies the IP addresses that are permitted or denied access to the printer. Enter a numeric value between 0 and 255 in each field. Specifies the subnet mask that are permitted or denied access to the printer. Enter a numeric value between 0 and 255 in each field. Reject Rejects printing from specified network address. Permit Permits printing from specified network address. Disabled Disables the IP Filter feature for the specified IP address. Copy Printer Settings The Copy Printer Settings menu includes the Copy Printer Settings and Copy Printer Settings Report pages. Copy Printer Settings Purpose: To copy the printer settings and ColorTrack (Internal Setting) to one or more of the same model of the printer.