Dell 5130 Color Laser User's Guide (PDF) - Page 176
Reset Wireless, TCP/IP, Dual Stack
View all Dell 5130 Color Laser manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
Manual Setup Ad-hoc WPS Push Button Control PIN Code Select to configure the wireless setting without the access point such as a wireless router. No Security Select to configure the wireless setting without specifying the security method from WEP. WEP Key Entry (64Bit) Specify the WEP 64bit Key to use through the wireless network. Up to 10 hexadecimal characters can be entered. Transmit Specify the transmit key from WEP Key 1, WEP Key 2, WEP Key Key 3, and WEP Key 4. WEP Key Entry (128Bit) Specify the WEP 128bit Key to use through the wireless network. Up to 26 hexadecimal characters can be entered. Transmit Specify the transmit key from WEP Key 1, WEP Key 2, WEP Key Key 3, and WEP Key 4. PBC Start Cancel* Start Disables the security method of WPS-PBC. Configures the wireless setting with the security method of WPS-PBC. Start Configuration Configures the wireless setting using the PIN code assigned automatically by the printer. Print PIN Prints PIN Code. Confirm it when entering PIN assigned to the printer into your Code computer. NOTE: This item is available only when connecting the printer with a wireless network. Reset Wireless Purpose: To initialize wireless network settings. After executing this function and rebooting the printer, all wireless network settings are reset to their default values. NOTE: This item is available only when connecting the printer with a wireless network. TCP/IP Purpose: To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on again. Values: IP Mode Dual Stack* IPv4 Mode IPv6 Mode Uses both IPv4 and IPv6 to set the IP address. Uses IPv4 to set the IP address. Uses IPv6 to set the IP address. AutoIP* Automatically sets the IP address. IPv4 Get IP Address BOOTP RARP DHCP Panel Uses BOOTP to set the IP address. Uses RARP to set the IP address. Uses DHCP to set the IP address. Enables the IP address entered on the operator panel. IP Address Sets the IP address allocated to the printer by using the keys on the operator panel. Subnet Mask Sets the subnet mask. Gateway Address Sets the gateway address. IPsec*1 Disables IPsec. *1 Only displayed when an optional network protocol adapter is installed and IPsec is enabled.