Dell 5130 Color Laser User's Guide (PDF) - Page 143

the paper package. Do not use paper that you have cut or trimmed yourself. Do not mix print media sizes, weights, or types in the same source. This may result in a paper jam. Do not remove the tray while a job is printing. Ensure that the paper is properly loaded in the tray. Flex paper back and forth, and then fan them. Straighten the edges of the stack on a level surface. Selecting Preprinted Media and Letterhead When selecting preprinted media and letterhead paper for the printer: Use grain long paper for best results. Use only media and letterhead printed using an offset lithographic or engraved printing process. Select paper that absorb ink, but do not bleed. Avoid paper with rough or heavily textured surfaces. Use paper printed with heat-resistant inks designed for use in xerographic copiers. The ink must withstand temperatures of 225°C (437°F) without melting or releasing hazardous emissions. Use inks that are not affected by the resin in toner or the silicone in the fuser. Inks that are oxidation-set or oilbased should meet these requirements; latex inks might not. If you are in doubt, contact your paper supplier. Printing on Letterhead Check with the manufacturer or vendor to determine whether the pre-printed letterhead you have selected is acceptable for laser printers. Page orientation is important when printing on letterhead. Use the following table for help when loading letterhead in the print media sources. Print media source Print side Face up Page orientation Tray 1 550-sheet feeder 1100-sheet feeder Letterhead enters the printer first Face down