Dell 5130 Color Laser User's Guide (PDF) - Page 410

Compile Exit SNR OFF Jam Action Yes No Remove the print media left in the H Transport Unit. 1 The task is complete. Contact Dell. Does this solve your problem? Set Eject Jam Action If using non-recommended print media, use the print media recommended for 1 the printer. Does this solve your problem? Check if the print media on the tray obstruct the output slot. 2 Remove the print media on the tray. Does this solve your problem? Check if the print media is curled. 3 Uncurl the print media and then set it again. Does this solve your problem? Wipe the separator rollers in tray 1 with a cloth moistened with water. 4 Does this solve your problem? Yes The task is complete. The task is complete. The task is complete. The task is complete. No Go to action 2. Go to action 3. Go to action 4. Contact Dell. Other Problems Problem Condensation has occurred inside the printer. Action This usually occurs within several hours after you heat the room in winter. This also occurs when the printer is operating in a location where relative humidity reaches 85% or more. Adjust the humidity or relocate the printer to an appropriate environment. Contacting Service When you call for printer service, be prepared to describe the problem you are experiencing or the error message on the display. You need to know your printer's model type and serial number. See the label located inside the side door of your printer. Back to Contents Page