Dell 5130 Color Laser User's Guide (PDF) - Page 178

Reject Rejects an access from the specified IP address. *1 This item is only available for LPD or Port9100. IEEE 802.1x Purpose: To disable the IEEE 802.1x authentication. The change becomes effective after the printer is turned off and then on again. NOTE: This item is displayed only when the IEEE 802.1x authentication is enabled. NOTE: This item is available only when connecting the printer with a wired network. Reset LAN Purpose: To initialize wired network data stored in NV (non-volatile) memory. After executing this function and rebooting the printer, all wired network settings are reset to their default values. Adobe Protocol Purpose: To specify PostScript communication protocol for a parallel interface, you can configure the Adobe Protocol settings for the wired network. The change becomes effective after the printer is turned off and then on again. Values: Auto Used when auto-detecting the PostScript communication protocol. Standard Used when the communication protocol is in ASCII interface. BCP Used when the communication protocol is in binary format. TBCP* Used when the communication protocol supports both ASCII and binary data to switch between them according to the specified control code. Binary Used when no special processing is required for data. Parallel Use the Parallel menu to change the parallel interface. NOTE: Values marked by an asterisk (*) are the factory default menu settings. Parallel Port Purpose: To enable or disable the parallel interface. The change becomes effective after the printer is turned off and then on again. Values: Disable The parallel interface is disabled. Enable* The parallel interface is enabled. ECP