HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Comma - Page 134

[Sysname-ospf-100-area-0.0.0.1] stub stub-router Syntax stub-router View undo stub-router OSPF view Default level 2: System level Parameters None Description Use stub-router to configure the router as a stub router. Use undo stub-router to restore the default. By default, no router is configured as a stub router. The router LSAs from the stub router may contain different link type values. A value of 3 means a link to the stub network, so the cost of the link remains unchanged. A value of 1, 2 or 4 means a point-to-point link, a link to a transit network or a virtual link; in such cases, a maximum cost value of 65535 is used. If other neighbors find the links to the stub router have such big costs, they will not send packets to the stub router as long as a route with a smaller cost exists. Examples # Configure the router as a stub router. system-view [Sysname] ospf 100 [Sysname-ospf-100] stub-router transmit-pacing Syntax transmit-pacing interval interval count count View undo transmit-pacing OSPF view Default level 2: System level Parameters interval: Interval at which an interface sends LSU packets, in milliseconds. Its value is in the range of 10 to 1000. If the router has a number of OSPF interfaces, HP recommends increasing this interval to reduce the total numbers of LSU packets sent by the router every second. 123