HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Comma - Page 237

OSPFv3 configuration commands The term "router" in the chapter refers to both routers and Layer 3 switches. abr-summary (OSPFv3 area view) Syntax abr-summary ipv6-address prefix-length [ not-advertise ] View undo abr-summary ipv6-address prefix-length OSPFv3 area view Default level 2: System level Parameters ipv6-address: Destination IPv6 address of the summary route. prefix-length: Prefix length of the destination IPv6 address, in the range of 0 to 128. This argument specifies the number of consecutive 1s of the prefix, which defines the network ID. not-advertise: Specifies not to advertise the summary IPv6 route. Description Use abr-summary to configure an IPv6 summary route on an area border router. Use undo abr-summary to remove an IPv6 summary route. Then the summarized routes are advertised. By default, no route summarization is available on an ABR. You can use this command only on an ABR to configure a summary route for the area. The ABR advertises only the summary route to other areas. Multiple contiguous networks may be available in an area, where you can summarize them with one route for advertisement. Examples # Summarize networks 2000:1:1:1::/64 and 2000:1:1:2::/64 in Area 1 with 2000:1:1::/48. system-view [Sysname] ospfv3 1 [Sysname-ospfv3-1] area 1 [Sysname-ospfv3-1-area-0.0.0.1] abr-summary 2000:1:1:: 48 area (OSPFv3 view) Syntax View area area-id OSPFv3 view 226