HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Comma - Page 280

Parameters no-summary: This argument is only applicable to the ABR of a stub area. With it configured, the ABR advertises only a default route in a Summary-LSA to the stub area (such an area is called a totally stub area). Description Use stub to configure an area as a stub area. Use undo stub to remove the configuration. By default, an area is not configured as a stub area. When an area is configured as a stub area, all the routers attached to the area must be configured with the stub command. Related commands: default-cost. Examples # Configure OSPFv3 area 1 as a stub area. system-view [Sysname] ospfv3 1 [Sysname-ospfv3-1] area 1 [Sysname-ospfv3-1-area-0.0.0.1] stub vlink-peer (OSPFv3 area view) Syntax vlink-peer router-id [ hello seconds | retransmit seconds | trans-delay seconds | dead seconds | instance instance-id ] * View undo vlink-peer router-id [ hello | retransmit | trans-delay | dead ] * OSPFv3 area view Default level 2: System level Parameters router-id: Router ID for a virtual link neighbor. hello seconds: Specifies the interval in seconds for sending Hello packets, ranging from 1 to 8192, with the default as 10. This value must be equal to the hello seconds configured on the virtual link peer. retransmit seconds: Specifies the interval in seconds for retransmitting LSA packets, ranging from 1 to 3600, with the default as 5. trans-delay seconds: Specifies the delay interval in seconds for sending LSA packets, ranging from 1 to 3600, with the default as 1. dead seconds: Specifies the neighbor dead time in seconds, ranging from 1 to 32768, with the default as 40. This value must be equal to the dead seconds configured on the virtual link peer, and at least four times the value of hello seconds. instance Instance-id: Instance ID of an virtual link, in the range of 0 to 255, with the default as 0. 269