HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Comma - Page 206

system-view [Sysname] bgp 100 [Sysname-bgp] peer 1.1.1.1 substitute-as # In BGP-VPN instance view, substitute local AS number for AS number of peer 1.1.1.1. (The VPN has been created.) system-view [Sysname] bgp 100 [Sysname-bgp] ipv4-family vpn-instance vpn1 [Sysname-bgp-ipv4-vpn1] peer 1.1.1.1 substitute-as peer timer (BGP/BGP-VPN instance view) Syntax peer { group-name | ip-address } timer keepalive keepalive hold holdtime View undo peer { group-name | ip-address } timer BGP view, BGP-VPN instance view Default level 2: System level Parameters group-name: Name of a peer group, a sting of 1 to 47 characters. ip-address: IP address of a peer. keepalive: Keepalive interval in seconds, ranging from 0 to 21845. holdtime: Holdtime interval in seconds, whose value is 0 or in the range of 3 to 65535. Description Use peer timer to configure the keepalive interval and holdtime interval for a peer or peer group. Use undo peer timer to restore the default. By default, the keepalive and holdtime are 60s and 180s. The timers configured with this command are preferred to the timers configured with the timer command. If the holdtime interval is configured as 0, no keepalive message will be sent to the peer, and the peer connection will never time out. If the keepalive interval is configured as 0 and the negotiated hold time is not 0, one third of the hold time is taken as the interval for sending keepalive messages. If neither the holdtime interval nor the keepalive interval is configured as 0, the holdtime interval must be at least three times the keepalive interval. After this command is executed, the peer connection is closed at once, and a new connection to the peer is negotiated using the configured hold time. Related commands: timer. Examples # In BGP view, configure the keepalive interval and holdtime interval for peer group test as 60s and 180s. system-view 195