HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Comma - Page 135
vlink-peer (OSPF area view
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
count: Maximum number of LSU packets sent by an interface at each interval. It is in the range of 1 to 200. If the router has a number of OSPF interfaces, HP recommends decreasing this interval to reduce the total numbers of LSU packets sent by the router every second. Description Use transmit-pacing to configure the maximum number of LSU packets that can be sent every the specified interval. Use undo transmit-pacing to restore the default. By default, an OSPF interface sends up to three LSU packets every 20 milliseconds. Examples # Configure all the interfaces under OSPF process 1 to send up to 10 LSU packets every 30 milliseconds. system-view [Sysname] ospf 1 [Sysname-ospf-1] transmit-pacing interval 30 count 10 vlink-peer (OSPF area view) Syntax vlink-peer router-id [ hello seconds | retransmit seconds | trans-delay seconds | dead seconds | simple [ cipher | plain ] password | { md5 | hmac-md5 } key-id [ cipher | plain ] password ] * View undo vlink-peer router-id [ hello | retransmit | trans-delay | dead | [ simple | { md5 | hmac-md5 } key-id ] ] * OSPF area view Default level 2: System level Parameters router-id: Router ID of the neighbor on the virtual link. hello seconds: Hello interval in seconds, in the range of 1 to 8192. The default is 10. It must be identical to the hello interval on the virtual link neighbor. retransmit seconds: Retransmission interval in seconds, in the range of 1 to 3600. The default is 5. trans-delay seconds: Transmission delay interval in seconds, in the range of 1 to 3600. The default is 1. dead seconds: Dead interval in seconds, in the range of 1 to 32768. The default is 40. It must be identical to that on the virtual link neighbor. The dead interval is at least four times the hello interval. md5: MD5 authentication. hmac-md5: HMAC-MD5 authentication. simple: Simple authentication. key-id: Key ID for MD5 or HMAC-MD5 authentication, in the range of 1 to 255. ciper: Sets a ciphertext password. plain: Sets a plaintext password. 124