HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Comma - Page 238

Default level 2: System level Parameters area-id: ID of an area, a decimal integer (in the range of 0 to 4294967295 and changed to IPv4 address format by the system) or an IPv4 address. Description Use area to enter OSPFv3 area view. The undo form of the command is not available. An area is removed automatically if no configuration is made and no interface is up in the area. Examples # Enter OSPFv3 Area 0 view. system-view [Sysname] ospfv3 1 [Sysname-ospfv3-1] area 0 [Sysname-ospfv3-1-area-0.0.0.0] bandwidth-reference Syntax bandwidth-reference value View undo bandwidth-reference OSPFv3 view Default level 2: System level Parameters value: Bandwidth reference value for link cost calculation, in the range of 1 to 2147483648 Mbps. Description Use bandwidth-reference to specify a reference bandwidth value for link cost calculation. Use undo bandwidth-reference to restore the default value. The default value is 100 Mbps. You can configure an OSPFv3 cost for an interface with one of the following methods: • Configure the cost value in interface view • Configure a bandwidth reference value, and OSPFv3 computes the cost automatically based on the bandwidth reference value: Interface OSPFv3 cost = Bandwidth reference value/Interface bandwidth. If the calculated cost is greater than 65535, the value of 65535 is used. If no cost value is configured for an interface, OSPFv3 computes the interface cost value automatically: Examples # Specify the reference bandwidth value as 1000 Mbps. system-view 227