HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Comma - Page 275

Use undo ospfv3 timer hello to restore the default . By default, the hello interval is 10 seconds for P2P and Broadcast interfaces, and is not supported on the P2MP or NBMA interfaces. Related commands: ospfv3 timer dead. Examples # Configure the hello interval as 20 seconds for an interface in instance 1. system-view [Sysname] interface vlan-interface 10 [Sysname-Vlan-interface10] ospfv3 timer hello 20 instance 1 ospfv3 timer retransmit Syntax ospfv3 timer retransmit interval [ instance instance-id ] View undo ospfv3 timer retransmit [ interval ] [ instance instance-id ] Interface view Default level 2: System level Parameters interval: LSA retransmission interval in seconds, ranging from 1 to 65535. instance-id: Instance ID of an interface, in the range of 0 to 255, which defaults to 0. Description Use ospfv3 timer retransmit to configure the LSA retransmission interval for an interface in an instance. Use undo ospfv3 timer retransmit to restore the default. The interval defaults to 5 seconds. After sending a LSA to its neighbor, the device waits for an acknowledgement. If receiving no acknowledgement after the LSA retransmission interval elapses, it will retransmit the LSA. The LSA retransmission interval should not be too small for avoidance of unnecessary retransmissions. Examples # Configure the LSA retransmission interval on an interface in instance 1 as 12 seconds. system-view [Sysname] interface vlan-interface 10 [Sysname-Vlan-interface10] ospfv3 timer retransmit 12 instance 1 ospfv3 timer poll Syntax ospfv3 timer poll seconds [ instance instance-id ] undo ospfv3 timer poll [ seconds ] [ instance instance-id ] 264