HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Comma - Page 348
apply cost-type, apply extcommunity
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 348 highlights
Examples # Configure node 10 in permit mode of routing policy policy1: set a cost of 120 for routing information whose outbound interface is Vlan-interface 20. system-view [Sysname] route-policy policy1 permit node 10 [Sysname-route-policy] if-match interface Vlan-interface 20 [Sysname-route-policy] apply cost 120 apply cost-type Syntax apply cost-type { internal | type-1 | type-2 } View undo apply cost-type Routing policy view Default level 2: System level Parameters internal: Sets the MED value for a matching BGP route as the IGP metric to the route's next hop. type-1: Sets the cost type to Type-1 external route of OSPF. type-2: Sets the cost type to Type-2 external route of OSPF. Description Use apply cost-type to set a cost type for routing information. Use undo apply cost-type to remove the clause configuration. No cost type is set for routing information by default. Use for BGP, the apply cost-type internal command sets the MED of a matching BGP route learned from an iBGP peer as the IGP metric to the route's next hop before BGP advertises the route to an eBGP peer. Examples # Create node 10 in permit mode of routing policy policy1: If a route has a tag of 8, set the cost type for the route to OSPF Type-1 external route. system-view [Sysname] route-policy policy1 permit node 10 [Sysname-route-policy] if-match tag 8 [Sysname-route-policy] apply cost-type type-1 apply extcommunity Syntax apply extcommunity { { rt route-target }& [ additive ] } undo apply extcommunity 337