HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Routing Comma - Page 231
ripng default-route, Disable RIPng process 100.
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
View System view Default level 2: System level Parameters process-id: RIPng process ID, in the range of 1 to 65535. The default value is 1. Description Use ripng to create a RIPng process and enter RIPng view. Use undo ripng to disable a RIPng process. By default, no RIPng process is enabled. • Before configuring global RIPng parameters, you must create a RIPng process. This requirement does not apply to interface RIPng parameter configuration. • After you disable a RIPng process, the RIPng parameters on interface running the process also become ineffective. Examples # Create RIPng process 100 and enter its view. system-view [Sysname] ripng 100 [Sysname-ripng-100] # Disable RIPng process 100. [Sysname] undo ripng 100 ripng default-route Syntax ripng default-route { only | originate } [ cost cost ] View undo ripng default-route Interface view Default level 2: System level Parameters only: Indicates that only the IPv6 default route (::/0) is advertised through the interface. originate: Indicates that the IPv6 default route (::/0) is advertised without suppressing other routes. cost: Metric of the advertised default route, in the range of 1 to 15, with a default value of 1. Description Use ripng default-route to advertise a default route with the specified routing metric to a RIPng neighbor. Use undo ripng default-route to stop advertising or forwarding the default route. By default, a RIP process does not advertise any default route. 220