Netgear GSM4248P User Manual - Page 100

AV Line of Fully Managed Switches M4250 Series Main User Manual 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 5. Select System > Services > DHCP Server > DHCP Server Configuration. The DHCP Server Configuration page displays. 6. Select the Admin Mode Disable or Enable radio button. This setting specifies whether the DHCP service is enabled or disabled. The default is Disable. 7. In the Ping Packet Count field, specify the number of packets a server sends to a pool address to check for duplication as part of a ping operation. The value can be 0 or from 2 to 10. Setting the value to 0 disables the function. The default is 2. 8. Select the Conflict Logging Mode Disable or Enable radio button. This setting specifies whether conflict logging on a DHCP server is enabled or disabled. The default is Enable. 9. Select the BootP Automatic Mode Disable or Enable radio button. This setting specifies whether BootP for dynamic pools is enabled or disabled. The default value is Disable. 10. To exclude addresses, do the following: a. In the IP Range From field, enter the lowest address in the range or a single address to be excluded. b. In the IP Range To field, to exclude a range, enter the highest address in the range. To exclude a single address, enter the same IP address as specified in the IP Range From field, or leave it as 0.0.0.0. c. Click the Add button. The addresses that must be excluded are added to the switch. 11. Click the Apply button. Your settings are saved. 12. To save the settings to the running configuration, click the Save icon. Configure Switch System 100 Information Main User Manual