Netgear GSM4248P User Manual - Page 285

AV Line of Fully Managed Switches M4250 Series Main User Manual 8. In the MVR Global Query Response Time field, set the period that the switch must wait for an IGMP group membership report from an interface before removing the interface as a member from the multicast group. This period applies only to the removal of the interface from the receiver port on the switch. When an IGMP query is sent from a receiver port, the switch waits for the default or configured MVR query time for an IGMP group membership report before removing the interface as a member from the multicast group. The period is equal to a tenths of a second. The range is from 1 to 100 tenths. The default is 5 tenths or one-half. 9. From the MVR Mode menu, select compatible or dynamic to specify the MVR mode of operation. Select compatible (the default mode) to block IGMP group membership reports on source ports. Select dynamic to allow IGMP group membership reports on source ports. 10. Click the Apply button. Your settings are saved. 11. To save the settings to the running configuration, click the Save icon. 12. To refresh the page, click the Refresh button. The following table describes the nonconfigurable fields on the page. Table 73. MVR configuration information Field MVR Max Multicast Groups Definition The maximum number of multicast groups that MVR supports. MVR Current Multicast Groups The number of the MVR groups allocated. Configure an MVR group You can configure an MVR group. After you configure interfaces for MVR, you can add them as members to the MVR group. To configure an MVR group: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login page displays. 3. Click the Main UI Login button. Configure Switching Information 285 Main User Manual