Netgear GSM4248P User Manual - Page 91

AV Line of Fully Managed Switches M4250 Series Main User Manual The main UI login page displays in a new tab. 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 5. Select System > Management > Green Ethernet > Green Ethernet Details. The Green Ethernet Details page displays. 6. From the Interface menu, select the interface. 7. From the Energy Detect Admin Mode menu, select to enable or disable this mode. By default, this mode is disabled for the interface. When a port link is down, the underlying physical layer goes down for a short period and then checks for port link pulses again so that auto-negotiation remains possible. In this way, the switch saves power when no link partner is present for the port. 8. From the EEE Admin Mode menu, select to enable or disable this mode. With Energy Efficient Ethernet (EEE) mode enabled, the port transitions to low power mode during a link idle condition. The default value is Disabled. 9. In the EEE Transmit Idle Time field, enter the period that the interface must remain idle (without receiving packets for transmission) before entering the low-power idle (LPI) state. The range is from 600 to 4294967295 seconds. The default is 600 seconds. 10. In the EEE Transmit Wake Time field, enter the period that the interface must remain in the LPI state before returning to the active state after it receives a packet for transmission. The range is from 8 to 65535 seconds. The default is 17 seconds. 11. Click the Apply button. Your settings are saved. 12. To save the settings to the running configuration, click the Save icon. The following table describes the nonconfigurable fields. Configure Switch System 91 Information Main User Manual