Netgear GSM4248P User Manual - Page 280

AV Line of Fully Managed Switches M4250 Series Main User Manual 7. In the VLAN ID field, enter the VLAN ID. 8. From the Multicast Router menu, select Enable or Disable to specify if the VLAN is a multicast router VLAN. 9. Click the Apply button. Your settings are saved. 10. To save the settings to the running configuration, click the Save icon. Configure the MLD snooping querier global settings You can configure the global settings for an MLD snooping querier on the switch. To configure the global settings for an MLD snooping querier: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login page displays. 3. Click the Main UI Login button. The main UI login page displays in a new tab. 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 5. Select Switching > Multicast > MLD Snooping > Querier Configuration. The Querier Configuration page displays. 6. Select the Querier Admin Mode Enable or Disable radio button to specify if MLD snooping is enabled for the switch. The default is Disable. 7. In the Querier Address field, specify the snooping querier IP address that must be used as the source address in periodic MLD queries. This address is used when no address is configured on the VLAN on which queries are sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and x::x. Note: The MLDP Version field always states MLD protocol version 1. This is the version that is used in periodic MLD queries. Configure Switching Information 280 Main User Manual