Netgear GSM4248P User Manual - Page 216

AV Line of Fully Managed Switches M4250 Series Main User Manual The following applies to GARP: • Registration occurs only on interfaces that receive a GARP PDU with a declaration or withdrawal. • Deregistration occurs only if all GARP participants that are connected to the same LAN segment as the interface withdraw the declaration. Configure GARP switch settings You can globally enable GARP VLAN registration protocol (GVRP) and GARP multicast registration protocol (GMRP) on the switch. To configure GARP switch settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login page displays. 3. Click the Main UI Login button. The main UI login page displays in a new tab. 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 5. Select Switching > VLAN > Advanced > GARP Switch Configuration. The GARP Switch Configuration page displays. 6. Select the GVRP Mode Disable or Enable radio button to disable or enable GARP VLAN registration protocol (GVRP) globally for the switch. If GVRP is enabled, the switch can share VLAN IDs with devices in the network. the The default is Disable. 7. Select the GMRP Mode Disable or Enable radio button to disable or enable GARP multicast registration protocol (GMRP) globally for the switch. If GVMP is enabled, the switch can share multicast information with devices in the network. the The default is Disable. 8. Click the Apply button. Your settings are saved. It can take up to 10 seconds for GARP configuration changes to take effect. 9. To save the settings to the running configuration, click the Save icon. Configure Switching Information 216 Main User Manual