Netgear GSM4248P User Manual - Page 417

AV Line of Fully Managed Switches M4250 Series Main User Manual 7. To refresh the page, click the Refresh button. The following table describes the nonconfigurable fields on the page. Table 118. IPv4 PIM neighbor information Field Interface Neighbor IP Up Time (hh:mm:ss) Expiry Time (hh:mm:ss) DR Priority Description The interface on which the PIM neighbor is connected. The IPv4 address of the PIM neighbor. The time that passed since the PIM device became a neighbor of the interface. The time remaining before the PIM neighbor ages out. The designated router (DR) priority of the PIM neighbor. Add an IPv4 PIM candidate rendezvous point configuration You can add an IPv4 PIM candidate rendezvous point (RP) configuration on an interface. To add an IPv4 PIM candidate RP configuration: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login page displays. 3. Click the Main UI Login button. The main UI login page displays in a new tab. 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 5. Select Routing > Multicast > PIM > Candidate RP Configuration. The Candidate RP Configuration page displays. 6. From the Interface menu, select the interface. 7. In the Group Address field, specify the group IPv4 address that is transmitted in candidate-RP-advertisements. Configure Multicast Routing 417 Main User Manual