Netgear GSM4248P User Manual - Page 423

AV Line of Fully Managed Switches M4250 Series Main User Manual To add or change a static IPv4 multicast route: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login page displays. 3. Click the Main UI Login button. The main UI login page displays in a new tab. 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 5. Select Routing > Multicast > Static Routes Configuration. The Static Routes Configuration page displays. 6. If you are changing an existing static multicast route, select the check box for the route. For an existing static route, you can change the metric only. 7. In the Source IP field, specify the IPv4 address of the multicast packet source. 8. In the Source Mask field, specify the subnet mask of the multicast packet source. 9. In RPF Neighbor field, specify the IPv4 address of the neighbor RPF router that is located between the switch and the multicast source. 10. In the Metric field, specify the link state cost of the path from the multicast source to the switch. The range is from 0 to 255. 11. Do one of the following: • If you are adding a new static multicast route, click the Add button. Your settings are saved. The static multicast route is added. • If you are changing an existing static multicast route, click the Apply button. Your settings are saved. 12. To save the settings to the running configuration, click the Save icon. Delete a static multicast route for an IPv4 address You can delete a static IPV4 multicast route that you no longer need. Configure Multicast Routing 423 Main User Manual