Netgear GSM4248P User Manual - Page 335

AV Line of Fully Managed Switches M4250 Series Main User Manual Your settings are saved. 8. To save the settings to the running configuration, click the Save icon. Configure the loop protection settings for interfaces and display the loop protection state Before you can configure loop protection for individual ports, you must globally enable loop protection (see Configure the global loop protection settings on page 334). To enable and configure loop protection for an interface and display the loop protection state on the switch: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login page displays. 3. Click the Main UI Login button. The main UI login page displays in a new tab. 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 5. Select Switching > L2 Loop Protection > L2 Loop Protection Configuration. The L2 Loop Protection Configuration page displays. 6. Select whether to display physical interfaces, LAGs, or both by clicking one of the following links above the table heading: • 1: Only physical interfaces are displayed. This is the default setting. • LAG: Only LAGs are displayed. • All: Both physical interfaces and LAGs are displayed. 7. Select one or more interfaces by taking one of the following actions: • To configure a single interface, select the check box associated with the interface, or type the interface number in the Go To Interface field and click the Go button. • To configure multiple interfaces with the same settings, select the check box associated with each interface. • To configure all interfaces with the same settings, select the check box in the heading row. Configure Switching Information 335 Main User Manual