Netgear GSM4248P User Manual - Page 184

AV Line of Fully Managed Switches M4250 Series Main User Manual To configure the global ISDP settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login page displays. 3. Click the Main UI Login button. The main UI login page displays in a new tab. 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 5. Select System > ISDP > Basic > Global Configuration. The Global Configuration page displays. 6. Select the Admin mode Disable or Enable radio button to specify is the ISDP service is disable or enabled. The default is Enabled. 7. In the Timer field, specify the period in seconds between the transmission of ISDP packets. The range is from 5 to 254 seconds. The default is 30 seconds. 8. In the Hold Time field, specify the hold time for ISDP packets that the switch transmits. The hold time specifies how long a receiving device must store information sent in the ISDP packet before discarding it. The range from 10 to 255 seconds. The default is 180 seconds. 9. Select the Version 2 Advertisements Disable or Enable radio button to specify if the switch can send ISDPv2 packets. The default is Enabled. 10. Click the Apply button. Your settings are saved. 11. To save the settings to the running configuration, click the Save icon. The following table describes the nonconfigurable fields on the page. Configure Switch System 184 Information Main User Manual