Netgear GSM4248P User Manual - Page 303

AV Line of Fully Managed Switches M4250 Series Main User Manual An Auto-LAG can form with up to eight interfaces as members. Interfaces are automatically selected for the Auto-LAG based on whether they are up and available and on the following conditions: • The interface is not already manually configured as a member of a LAG. • The interface is not manually configured as a trunk port or an access port. That is, the interface must be a general interface. Note: The switch can support multiple static and dynamic LAGs, but with each partner device, the switch can support a single Auto-LAG only. Enable or disable Auto-LAGs By default, the Auto-LAG feature is globally enabled but you can globally disable it. To enable or disable Auto-LAGs: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login page displays. 3. Click the Main UI Login button. The main UI login page displays in a new tab. 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 5. Select Switching > LAG > LAG Configuration. The LAG Configuration page displays. 6. In the LAG Global Configuration section, select the Auto-LAG Admin Mode Enable or Disable radio button. By default, the Auto-LAG feature is globally enabled. 7. Click the Apply button. Your settings are saved. 8. To save the settings to the running configuration, click the Save icon. Configure Switching Information 303 Main User Manual