Netgear GSM4248P User Manual - Page 272

AV Line of Fully Managed Switches M4250 Series Main User Manual This enables or disables an MLD proxy querier on the system. If it is disabled, then an MLD proxy query with source IP 0::0 is not sent in response to an MLD leave packet. If it is enabled, then MLD proxy queries are sent. The default is Enable. 8. Select the Exclude Mrouter Interface Mode Enable or Disable radio button. This selection specifies the type of information that is forwarded to the upstream multicast router interface. If enabled, the switch blocks all unknown multicast data through the mrouter port, whether the port is configured dynamically or statically. Only MLD PDUs are allowed to pass through the mrouter port to the upstream router interface. The default is Enable. If disabled, the switch forwards both unknown multicast data and MLD PDUs to the upstream multicast router interface. Note: For information about MLD Plus mode, see Configure MLD snooping automatically with MLD Plus mode on page 269. 9. Click the Apply button. Your settings are saved. 10. To save the settings to the running configuration, click the Save icon. 11. To refresh the page, click the Refresh button. The following table describes the nonconfigurable fields on the page. Table 71. MLD snooping configuration information Field Definition Multicast Control Frame Count The number of multicast control frames that were processed. Interfaces Enabled for MLD Snooping The interface on which MLD snooping is administratively enabled. MLD snooping must be enabled globally and on an interface for the interface to be able to snoop MLD packets to determine which segments should receive multicast packets directed to the group address. VLAN IDs Enabled For MLD Snooping The VLAN on which MLD snooping is administratively enabled. Configure the MLD snooping settings for interfaces You can configure the MLD snooping settings for interfaces. Configure Switching Information 272 Main User Manual