Netgear GSM4248P User Manual - Page 717

AV Line of Fully Managed Switches M4250 Series Main User Manual 8. To save the settings to the running configuration, click the Save icon. The following table describes the nonconfigurable fields on the page. Table 171. Trap log information Field Description Number of Traps Since Last The number of traps that occurred since the switch last rebooted. Reset Trap Log Capacity The maximum number of traps stored in the log. If the number of traps exceeds the capacity, the new entries overwrite the oldest entries. Number of Traps since log last viewed The number of traps that occurred since the traps were last displayed. Note: If you save the trap log to another device (that is, you upload the file from the switch), this counter is set to 0. Log System Up Time Trap The sequence number of this trap. The time when this trap occurred, expressed in days, hours, minutes and seconds, since the last reboot of the switch. Information about the trap. Event log You can display and clear the event log, which contains error messages from the switch. Note: If you reset the switch to factory default settings, the event log is not cleared. To display or clear the event log: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login page displays. 3. Click the Main UI Login button. The main UI login page displays in a new tab. 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. Monitor the Switch and Network 717 Main User Manual