Netgear GSM4248P User Manual - Page 51

AV Line of Fully Managed Switches M4250 Series Main User Manual 8. Select the Configuration Method DHCP or Manual radio button to specify the switch startup action: • DHCP: The switch requests IP address information from a DHCP server. • Manual: The switch loads the IP address information that you specify: • IP Address: Specify the IP address of the interface. The default value is 169.254.100.100. • Subnet Mask: Specify the IP subnet mask for the interface. This is also referred to as the subnet/network mask and defines the portion of the interface's IP address that is used to identify the attached network. The default value is 255.255.0.0. • Gateway: Specify the gateway for the interface. The default value is 0.0.0.0. 9. Click the Apply button. Your settings are saved. 10. To save the settings to the running configuration, click the Save icon. Note: If you need to reset the IPv4 management VLAN, in the Reset IPv4 Management Interface section of the page, select the Set Management Interface to Default check box and click the Apply button. Doing so deletes the port-based IPv4 management interface configuration and sets the IPv4 management interface back to the default VLAN 1. The Current IPv4 Management Interface Status section displays the following nonconfigurable fields. Table 12. Nonconfigurable IPv4 management interface status information Field Description Management Interface Displays the current IPv4 management VLAN. Link State Indicates whether the link status is up or down. Routing Interface Status Indicates whether the link status is up or down for the management interface. MAC Address The MAC address assigned to the management interface. IP Address Configuration Method Indicates whether the IP address configuration method is DHCP or manual. IP Address The IP address of the management interface. Configure Switch System 51 Information Main User Manual