Netgear GSM4248P User Manual - Page 466

AV Line of Fully Managed Switches M4250 Series Main User Manual • Policing disabled: If policing is disabled, all traffic is marked as follows: - High: Sets the policy mark to ipdscp ef. - Medium: Sets the policy mark to ipdscp af31. - Low: Sets the policy mark to ipdscp be. • Adds each selected port and LAG to the policy. Use the DiffServ wizard to create a traffic class and policy for one or more interfaces To use the DiffServ wizard to create a traffic class and policy for one or more interfaces: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login page displays. 3. Click the Main UI Login button. The main UI login page displays in a new tab. 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 5. Select QoS > DiffServ > DiffServ Wizard. The DiffServ Wizard page displays. 6. From the Traffic Type menu, define the DiffServ class by selecting VOIP, HTTP, FTP, Telnet, or Every. 7. In the Committed Rate (Kbps) field, specify the rate in Kbps that applies to the traffic in the class. The range is from 1 to the maximum supported bandwidth on the interface. The default is 1 Kbps. The committed rate is applied if policing is enabled (which it is by default): • Policing enabled: The committed rate is applied to the policy and the policing action is set to conform. • Policing disabled: The committed rate is not applied and the policy is set to markdscp. Configure Quality of Service 466 Main User Manual