Netgear GSM4248P User Manual - Page 738

AV Line of Fully Managed Switches M4250 Series Main User Manual 5. Select Maintenance > Reset > Device Reboot. The Device Reboot page displays. 6. Select one of the following radio buttons: • Save prior to reboot: The switch saves all changes that you made and for which you did not click the Save icon in the main local browser interface. • Don't save prior to reboot: The switch does not save the changes that you made and for which you did not click the Save icon in the main local browser interface. 7. Click the Apply button. An Alert pop-up window displays. 8. Click the OK button to confirm. The switch reboots. Reset the switch to the factory default settings You can reset the switch configuration to the factory default values. All changes that you made are erased. If the IP address changes, your web session might disconnect. Note: If you reset the switch to the default configuration, the management IP address is reset to 169.254.100.100, and the DHCP client is enabled. No IP address is set for the OOB port, but its DHCP client is enabled. If you lose network connectivity after you reset the switch to the factory defaults, see Log in to the main UI with a web browser on page 24. To reset the switch to the factory default settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login page displays. 3. Click the Main UI Login button. The main UI login page displays in a new tab. 4. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. Maintenance and Troubleshooting 738 Main User Manual