Netgear GSM4248P User Manual - Page 658

AV Line of Fully Managed Switches M4250 Series Main User Manual • IPv6 • IPX • MPLS Multicast • MPLS Unicast • NetBios • Novell • PPPOE • RARP • User Value 17. If you select User Value from the EtherType Key menu, in the EtherType User Value field, specify the customized EtherType value that must be used. This value must be compared against the information in an Ethernet frame. The range is from 0x0600 to 0xFFFF. 18. In the Source MAC field, specify the source MAC address that must be compared against the information in an Ethernet frame. The format is xx:xx:xx:xx:xx:xx. 19. In the Source MAC Mask field, specify the source MAC address mask that must be compared against the information in an Ethernet frame. The format is xx:xx:xx:xx:xx:xx. 20. In the VLAN field, specify the VLAN ID that must be compared against the information in an Ethernet frame. The range is from 1 to 4093. You can configure either a single VLAN or a VLAN range. 21. From the Logging menu, select whether to enable or disable logging. This option is available if the selection from the Action menu is Deny. If you select Enable, logging is enabled for this ACL rule (subject to resource availability on the switch). If the access list trap flag is also enabled, periodic traps are generated, indicating the number of times the rule was evoked during the report interval, which is fixed at five minutes. 22. In the Rate Limit Conform Data Rate field, specify the value of the conforming data rate, which is the data rate at which confirming traffic is limited. The range is from 1 to 4294967295 Kbps. 23. In the Rate Limit Burst Size field, specify the value of the burst size, which is the size at which bursts of traffic above the confirming data rate are permitted. The range is from 1 to 128 Kbps. Manage Switch Security 658 Main User Manual