HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.x administrator guide (5697 - Page 236

3. Enter the dlsSet command to enable DLS or enter the dlsReset command to disable it. switch:admin> dlsshow DLS is not set switch:admin> dlsset switch:admin> dlsshow DLS is set switch:admin> dlsreset switch:admin> dlsshow DLS is not set Viewing routing path information The topologyShow and uRouteShow commands provide information about the routing path. 1. Connect to the switch and log in as admin. 2. Enter the topologyShow command to display the fabric topology, as it appears to the local switch: switch:admin> topologyshow 4 domains in the fabric; Local Domain ID: 2 Domain: Metric: Name: Path Count: 1 10500 fcr_xd_1_1 1 Hops: Out Port: In Ports: Total Bandwidth: Bandwidth Demand: Flags: 2 39 35 56 4.000 Gbps 300 % D The following information displays: Local Domain ID The domain number of the local switch. Domain The domain number of the destination switch. Metric The cost of reaching the destination domain. Name The name of the destination switch. Path Count The number of currently active paths to the destination domain. Hops The maximum number of switch-to-switch links (ISLs) transversed to reach the destination domain. Out Port The port to which the incoming frame will be forwarded in order to reach the destination domain. In Ports The input ports that use the corresponding Out Port to reach the destination domain. Total Bandwidth The maximum bandwidth of the out port. Bandwidth Demand The maximum bandwidth demand of the in ports. Flags An indication whether the route is dynamic (D) or static (S). This value is always "D", indicating a dynamic path. 236 Routing traffic