HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.x administrator guide (5697 - Page 79

To add a RADIUS server to the switch configuration: 1. Connect to the switch and log in using an admin account. 2. Enter this command: switch:admin> aaaConfig --add [-p port] [-s secret] [-t timeout] [-a pap | chap | peap-mschapv2] server Enter either a server name or IPv4 or IPv6 address. Avoid duplicating server listings (that is, listing the same server once by name and again by IP address). Up to five servers can be added to the configuration. -p port Optional: Enter a server port. The default is port 1812. -s secret Optional: Enter a shared secret. The default is "sharedsecret". Secrets can be from 8 to 40 alphanumeric characters long. Make sure that the secret matches that configured on the server. -t timeout Optional: Enter the length of time (in seconds) that the server has to respond before the next server is contacted. The default is three seconds. Time-out values can range from 1 to 30 seconds. -a Specify PAP, CHAP or PEAP as authentication [pap|chap|peap-msc protocol. Use peap-mschapv2 to provide hapv2] encrypted authentication channel between the switch and server. To add an LDAP server to the switch configuration: 1. Connect to the switch and log in using an admin account. 2. Enter this command: switch:admin> aaaConfig --add [-p port] [-t timeout] [-d domain_name] server -p port -t timeout -d domain_name Enter either a server name or IPv4 address. Microsoft's Active Directory does not support IPv6 addresses. Avoid duplicating server listings (that is, listing the same server once by name and again by IP address). Up to five servers can be added to the configuration. Optional: Enter a server port. The default is port 389. Optional: Enter the length of time (in seconds) that the server has to respond before the next server is contacted. The default is three seconds. Time-out values can range from 1 to 30 seconds. Enter the name of the Windows domain. At least one RADIUS or LDAP server must be configured before you can enable the RADIUS or LDAP service. If no RADIUS or LDAP configuration exists, turning it on triggers an error message. When the command succeeds, the event log indicates that the configuration is enabled or disabled. Fabric OS 6.1.x administrator guide 79