HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.x administrator guide (5697 - Page 258

Enabling the iSCSI gateway service The iSCSI gateway service translates and directs SCSI traffic between an iSCSI initiator and an FC target. This section explains how to enable the iSCSI gateway service on the 4/256 SAN Director. 1. Connect and log in to the switch. 2. Enter the fosConfig --show command to show the current Fabric OS configuration. switch:admin> fosconfig --show FC Routing service:disabled iSCSI service:disabled iSNS Client service: disabled 3. Enter the fosConfig --enable command to enable the iSCSI gateway service. switch:admin> fosconfig --enable iscsi iSCSI service is enabled 4. Verify that the iSCSI gateway service is enabled. switch:admin> fosconfig --show FC Routing service:disabled iSCSI service:enabled iSNS Client service:disabled Enabling GbE ports By default, GbE ports are enabled on an FC4-16IP blade installed in the 4/256 SAN Director. However, if you insert the FC4-16IP blade into a slot that was previously occupied by an FR-18i blade, GbE ports are disabled. Before enabling the physical iSCSI interface, enable the iSCSI gateway service as described in "Enabling the iSCSI gateway service" on page 258. NOTE: The GbE port number below is entered geX; where X is from 0 through 7. For example ge1 (see Figure 22 on page 257). 1. Connect and log in to the switch. 2. Enter the portCfgShow command with the blade slot number and GbE port number parameters to display the Persistent Disable setting of the port. switch:admin> portcfgshow 10/ge0 Mode: ISCSI Persistent Disable: ON Ipif configuration: Interface IP Address NetMask MTU 0 30.0.130.100 255.255.0.0 1500 Arp configuration: IP Address Mac Address Iproute Configuration: IP Address Mask Gateway Metric switch:admin> 258 iSCSI Gateway services