HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.x administrator guide (5697 - Page 294

• Traffic prioritization is not supported on mirrored ports. • Trunking considerations: If some ports in a trunk group have QoS enabled and some ports have QoS disabled, then two different trunks are formed, one with QoS enabled and one with QoS disabled. • Traffic prioritization is enforced on the egress ports only, not on the ingress ports. Setting traffic prioritization 1. Connect to the switch and log in as admin. 2. Enter the zoneCreate command, using the following syntax: zonecreate "QOSp_zonename", "member[; member...]" where: p The priority of the traffic. Possible values are: zonename member • HHigh priority • LLow priority The user-defined part of the name of the zone to be created. A member or list of members to be added to the zone. A zone member must be specified using WWN only. 3. Enter the cfgAdd command to add the QoS zone to the zone configuration, using the following syntax: cfgadd "cfgname", "QOSp_zonename" where: cfgname The name of the zone configuration. QOSp_zonename The name of the QoS zone to be added to the configuration. 4. Enter the cfgSave command to save the change to the defined configuration. 5. Enter the cfgEnable command for the appropriate zone configuration to make the change effective. cfgenable "cfgname" where: cfgname The name of the zone configuration. 6. Enter the portCfgQos command to enable QoS on the E_Ports, using the following syntax: portcfgqos --enable [slot/]port where: slot/port The slot and port number of the E_Port on which you want to enable QoS. The slot number is required for a 4/256 SAN Director or DC Director. 294 Optimizing fabric behavior