HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.x administrator guide (5697 - Page 391

SACK on Min Retransmit Time 100 Keepalive Timeout 80 Max Retransmissions 9 Status : Active Uptime 1 day, 23 hours, 24 minutes, 46 seconds IKE Policy 7 Authentication Algorithm: MD5 Encryption: 3DES Perfect Forward Secrecy: off Diffie-Hellman Group: 1 SA Life (seconds): 200000 IPSec Policy 7 Authentication Algorithm: AES-XCBC Encryption: 3DES SA Life (seconds): 1500000 Pre-Shared Key 1234567890123456 Persistently disabling ports Ports used on an FCIP tunnel must be persistently disabled before you can configure FCIP tunnels. you must change their state from persistently disabled to persistently enabled. 1. Enter the portCfgShow command to view ports that are persistently disabled. 2. After identifying the ports, enter the portCfgPersistentDisable command to disable any ports that you will use in the FCIP tunnel configuration. Configuring VEX ports If you are going to use a VEX port in your tunnel configuration, use the portCfgVexport command to configure the port as a VEX port. Remember that a VEX port must be paired with a VE port. VEX ports cannot communicate with other VEX ports. The command syntax is as follows. portcfgvexport [slot/]ge0|ge1 [-a 1|2] [-f fabricid] [-d domainid] [-p 1|2|3] [-t 1|2] Where: slot ge0|ge1 -a 1|2 -f fabricid -d domainid -p 1|2|3 -t 1|2 The number of a slot in a 4/256 SAN Director or DC SAN Backbone Director (short name, DC Director) chassis that contains an FR4-18i blade. This parameter does not apply to the stand-alone 400 Multi-protocol Router. The Ethernet port used by the tunnel (ge0 or ge1). Enables or disables admin (1 to enable or 2 to disable). The fabric ID (a number from 1 to 128). The preferred Domain ID (a number from 1 to 239). The port ID format (1 for core, 2 for extended edge, and 3 for native). Specify 1 to enable or 2 to disable negotiate fabric parameters. Fabric OS 6.1.x administrator guide 391