HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.x administrator guide (5697 - Page 50

3. Verify the threshold settings you have configured for each parameter. Enter the switchStatusPolicyShow command to view your current switch status policy configuration. HP StorageWorks 4/8 SAN Switch and 4/16 SAN Switch, 8/8 SAN Switch, 8/24 SAN Switch, 8/40 SAN Switch, 8/80 SAN Switch, Brocade 4Gb SAN Switch for HP p-Class BladeSystem, Brocade 4Gb SAN Switch for HP c-Class BladeSystem, SAN Switch 4/32, 4/64 SAN Switch, SAN Switch 4/32B, 400 Multi-protocol Router: switch:admin> switchstatuspolicyset To change the overall switch status policy parameters The current overall switch status policy parameters: Down Marginal PowerSupplies 2 1 Temperatures 2 1 Fans 2 1 Flash 0 1 MarginalPorts 2 1 FaultyPorts 2 1 MissingSFPs 0 0 Note that the value, 0, for a parameter, means that it is NOT used in the calculation. ** In addition, if the range of settable values in the prompt is (0..0), ** the policy parameter is NOT applicable to the switch. ** Simply hit the Return key. Bad PowerSupplies contributing to DOWN status: (0..2) [2] 0 Bad PowerSupplies contributing to MARGINAL status: (0..2) [1] 0 Bad Temperatures contributing to DOWN status: (0..6) [2] 0 Bad Temperatures contributing to MARGINAL status: (0..6) [1] 0 Bad Fans contributing to DOWN status: (0..3) [2] 0 Bad Fans contributing to MARGINAL status: (0..3) [1] 0 Out of range Flash contributing to DOWN status: (0..1) [0] 0 Out of range Flash contributing to MARGINAL status: (0..1) [1] 0 MarginalPorts contributing to DOWN status: (0..32) [2] 0 MarginalPorts contributing to MARGINAL status: (0..32) [1] 0 FaultyPorts contributing to DOWN status: (0..32) [2] 0 FaultyPorts contributing to MARGINAL status: (0..32) [1] 0 MissingSFPs contributing to DOWN status: (0..32) [0] 0 MissingSFPs contributing to MARGINAL status: (0..32) [0] 0 Policy parameter set has been changed rint12:admin> 4/256 SAN Director and DC SAN Backbone Director (short name, DC Director): Command output includes parameters related to CP blades. Configuring the audit log When managing SANs, you may want to filter, or audit certain classes of events to ensure that you can view and generate an audit log for what is happening on a switch, particularly for security-related event changes if you are running a Fabric OS version earlier than 6.x. These events include login failures, zone configuration changes, firmware downloads, and other configuration changes-in other words-critical changes that have a serious effect on the operation and security of the switch. Important information related to event classes is also tracked and made available. For example, you can track changes from an external source by the user name, IP address, or type of management interface used to access the switch. Auditable events are generated by the switch and streamed to an external host through a configured system message log daemon (syslog). You specify a filter on the output to select the event classes that are sent through the system message log. The filtered events are streamed chronologically and sent to the system message log on an external host in the specified audit message format. This ensures that they can 50 Standard features