HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.x administrator guide (5697 - Page 290

Deleting a TI zone Use the zone --delete command to delete a TI zone from the defined configuration. This command deletes the entire zone; to only remove port members from a TI zone, use the zone --remove command, as described in "Modifying TI zones" on page 288. To delete a TI zone: 1. Connect to the switch and log in as admin. 2. Enter the zone --delete command. zone --delete name where: name The name of the zone to be deleted. You can delete multiple zones by separating the zone names with a semicolon and enclosing them in quotation marks. 3. Enter the cfgEnable command for the appropriate zone configuration to make the change effective. To delete the TI zone redzone, type: zone --delete redzone Displaying TI zones Use the zone --show command to display information about TI zones. This command displays the following information for each zone: • zone name • E_Port members • N_Port members • failover option (enabled or disabled) • zone status (activated or deactivated) To display information about TI zones: 1. Connect to the switch and log in as admin. 2. Enter the zone --show command. zone --show [ name ] where: name The name of the zone to be displayed. If the name is omitted, the command displays information about all TI zones in the defined configuration. To display information about the TI zone redzone, type: zone --show redzone To display information about all TI zones, type: zone --show QoS: ingress rate limiting Ingress rate limiting is a licensed feature that restricts the speed of traffic from a particular device. Use ingress rate limiting for the following situations: • To reduce existing congestion in the network or proactively avoid congestion. • To enable you to offer flexible bandwidth limit services based on requirements. • To enable more important devices to use the network bandwidth during specific services, such as network backup. 290 Optimizing fabric behavior