HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2 administrator guide (5697-0 - Page 159

Setting up LDAP for FIPS mode 1. Set the switch authentication mode and add your LDAP server by using the commands in the example below. Provide the Fully Qualified Domain Name (FQDN) of the Active Directory server for the hostname parameter while configuring LDAP. Example: Setting up LDAP for FIPS mode switch:admin> aaaconfig --add GEOFF5.ADLDAP.LOCAL -conf ldap -d adldap.local -p 389 -t 3 switch:admin> aaaconfig --authspec "ldap;local" switch:admin> aaaconfig -show RADIUS CONFIGURATIONS RADIUS configuration does not exist. LDAP CONFIGURATIONS Position Server Port Domain Timeout(s) : 1 : GEOFF5.ADLDAP.LOCAL : 389 : adldap.local : 3 Primary AAA Service: LDAP Secondary AAA Service: Switch database 2. Configure the DNS on the switch using the dnsConfig command. Example: Setting the DNS switch:admin> dnsconfig Enter option 1 Display Domain Name Service (DNS) configuration 2 Set DNS configuration 3 Remove DNS configuration 4 Quit Select an item: (1..4) [4] 2 Enter Domain Name: [] domain.com Enter Name Server IP address in dot notation: [] 123.123.123.123 Enter Name Server IP address in dot notation: [] 123.123.123.124 DNS parameters saved successfully Enter option 1 Display Domain Name Service (DNS) configuration 2 Set DNS configuration 3 Remove DNS configuration 4 Quit Select an item: (1..4) [4] 4 Specify the DNS IP address using either IPv4 or IPv6. This is needed for the switch to resolve the domain name to the IP address as LDAP initiates a TCP session to connect to your Microsoft Active Directory server. A Fully Qualified Domain Name (FQDN) is needed to validate the server identity as recorded in the common name of the server certificate. 3. Set up LDAP according to the instructions in "LDAP configuration and Microsoft Active Directory" on page 93. Fabric OS 6.2 administrator guide 157