HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2 administrator guide (5697-0 - Page 553
Setting the IP address for the CP inband management interface
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 553 highlights
routeadd destination netmask [gateway] routedel destination netmask destination netmask gateway Adds a route to the management station for an existing CP or GbE port (CP or GbE designation is made automatically). You must specify the destination IP address and the subnet mask when adding a management route. You must create the IP addresses for the CP and the GbE port interfaces before you can add a route to the routing table. Deletes a management route from an internal CP or a GbE port interface. This operand is optional if the destination is in the same subnet as one of the IP interface addresses. If the destination is not part of the same subnet, you must specify a gateway IP address. Specifies the destination for the route. This is the IP address of the management station. This operand is required when adding or deleting a route. Specifies the subnet mask. This operand is required when adding or deleting a route. Specifies the gateway IP address. This operand is optional if the destination is in the same subnet as one of the IP interface addresses. If the destination is not part of the same subnet, you must specify a gateway IP address. Setting the IP address for the CP inband management interface The portCfg inbandmgmt command stores the IP address of the CP inband management interface and routes in the configuration database and updates the current configuration to use these new settings. To add the IP address to the internal interface on the CP, use the 'cp' option for the portCfg inbandmgmt ipaddrset command. 1. Connect to the switch and log in as admin. 2. Enter the portCfg inbandmgmt command to configure an IP address on the CP. switch:admin> portcfg inbandmgmt ge0 ipaddrset cp 192.168.255.1 255.255.255.0 Setting the IP address for the GE inband management interface To set the IP address on the internal interface for the GE port processor, use the 'ge' option for the portCfg inbandmgmt ipaddrset command. These commands will set the appropriate interface based on the GE port number entered. 1. Connect to the switch and log in as admin. 2. Enter the portCfg inbandmgmt command to configure an IP address to the internal interface on the GE port processor. switch:admin> portcfg inbandmgmt ge0 ipaddrset ge 192.168.255.2 255.255.255.0 Adding a route on the CP 1. Connect to the switch and log in as admin. 2. Enter the portCfg inbandmgmt command to add a route to the Management Station. switch:admin> portcfg inbandmgmt ge0 routeadd 192.168.3.0 255.255.255.0 Deleting a route 1. Connect to the switch and log in as admin. 2. Enter the portCfg inbandmgmt command to delete a route to the Management Station. switch:admin> portcfg inbandmgmt ge0 routedel 192.168.3.0 255.255.255.0 Specifying the portCfg inbandmgmt command with the routeadd or routedel options adds and deletes route entries to the CP and the GE port processor routing tables. IP addresses must be configured for both devices prior to configuring any routes. When configuring the routes for the CP, the GE port processor inband device address for that GE port is used instead of the specified gateway. If no gateway Fabric OS 6.2 administrator guide 549