HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2 administrator guide (5697-0 - Page 399

Setting up LSAN zone binding 1. Log in to the FC router as admin. 2. Enter the following command to add a pair of FC routers that can access each other: FCR:Admin > fcrlsanmatrix --add -fcr wwn1 wwn2 where wwn1 and wwn2 are the WWNs of the FC routers. 3. Enter the following command to add a pair of edge fabrics that can access each other: FCR:Admin > fcrlsanmatrix --add -lsan fid1 fid2 where fid1 and fid2 are the FIDs of the edge fabrics. 4. Enter the following command to apply the changes persistently: FCR:Admin > fcrlsanmatrix --apply -all Viewing the LSAN zone binding matrixes 1. Log on to the FC router as admin. 2. Enter the following command to view the FC router matrix: FCR:Admin > fcrlsanmatrix --fabricview -fcr Example: FCR:Admin > fcrlsanmatrix --fabricview -fcr SAVED FCR PAIRS FCR FCR 10:00:00:60:69:c3:12:b2 (2)10:00:00:60:69:c3:12:b3 (unknown) 3. Enter the following command to view the LSAN fabric matrix: FCR:Admin > fcrlsanmatrix --fabricview -lsan Example: FCR:Admin > fcrlsanmatrix --fabricview -lsan LSAN MATRIX is activated Fabric ID 1 Fabric ID 2 4 5 4 7 10 19 Default LSAN Matrix: 1 2 8 Proxy PID configuration When an FC router is first configured, the PIDs for the proxy devices are automatically assigned. Proxy PIDs (as well as phantom domain IDs) persist across reboots. The most common situation in which you would set a proxy PID is when you replace a switch. If you replace the switch and want to continue using the old PID assignments, you can configure it to do so; this value remains in the system even if the blade is replaced. To minimize disruption to the edge fabrics, set the proxy PIDs to the same values used with the old hardware. The fcrProxyConfig command is displayed or sets the persistent configuration of proxy devices. Used with the -s slot option, it can also influence the assignment of the xlate domain port number (which is Fabric OS 6.2 administrator guide 397