HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2 administrator guide (5697-0 - Page 481

The following example shows two routes being added to an interface: switch:admin06> portcfg iproute 8/ge0 create 192.168.11.0 255.255.255.0 192.168.100.1 1 switch:admin06> portcfg iproute 8/ge0 create 192.168.12.0 255.255.255.0 192.168.100.1 1 The following example verifies that the two routes have been successfully created: switch:admin06> portshow iproute 8/ge0 Slot: 8 Port: ge0 IP Address Mask Gateway Metric Flags 192.168.100.0 255.255.255.0 192.168.100.40 0 Interface 192.168.100.0 255.255.255.0 192.168.100.41 0 Interface 192.168.11.0 255.255.255.0 192.168.100.1 1 192.168.12.0 255.255.255.0 192.168.100.1 1 3. If you are implementing VLAN tagging, create a static ARP entry for the IP interfaces on both ends of the tunnel, using the portCfg arp command with the add option. The command syntax is as follows. portCfg arp [slot/]ge0|ge1 add ipaddr macaddr You can obtain the MAC address (macaddr) by using the portShow arp command with the -lmac option. 4. Verify IP connectivity by entering the portCmd --ping command to test the connection to a destination IP address from a source IP address on one of the local Ethernet ports (Ge0 or Ge1). This verification also ensures that data packets can be sent to the remote interface. You can test a connection only if both ports have IP interfaces set. The command syntax is as follows. portCmd --ping [slot/]ge0|ge1 [-s source_ip] [-d dest_ip] [-c L2 class-of-service] [-n num-requests] [-q type-of-service] [-t ttl] [-v vlan tag] [-w wait-time] [-z size] where: slot ge0|ge1 The number of a slot in an HP StorageWorks 4/256 SAN Director and HP StorageWorks DC SAN Backbone Director or HP StorageWorks DC04 SAN Director Switch platforms that contains an FR4-18i blade. This parameter does not apply to the stand-alone HP StorageWorks 400 Multi-Protocol Router. The Ethernet port used by the tunnel (ge0 or ge1) -s source_ip The source IP interface that originates the ping request. -d destination_ip The destination IP address for the ping request. -c class-of-service The Layer 2 class of service (L2CoS). -n num-requests The number of ping requests to make. The default is 4. -q type-of-service The DiffServ QoS. The default is 0 (zero). The value must be an integer in the range from 0 through 255. -t ttl The time to live. The default value is 100. -v vlan tag The vlan tag for a VLAN tagged IP connection. -w wait-time The time to wait for the response of each ping request. This parameter is specified in milliseconds and the default value is 5000 milliseconds (5 sec). The maximum allowed wait time for ping is 29000 milliseconds (29 sec). Fabric OS 6.2 administrator guide 477