HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2 administrator guide (5697-0 - Page 413

Setting a mask for an end-to-end monitor End-to-end monitors count the number of words in Fibre Channel frames that match a specific SID/DID pair. If you want to match only part of the SID or DID, you can set a mask on the port to compare only certain parts of the SID or DID. By default, the frame must match the entire SID and DID to trigger the monitor. By setting a mask, you can choose to have the frame match only one or two of the three fields (Domain ID, Area ID, and AL_PA) to trigger the monitor. You specify the masks in the form dd:aa:pp, where dd is the domain ID mask, aa is the area ID mask, and pp is the AL_PA mask. The values for dd, aa, and pp are either ff (the field must match) or 00 (the field is ignored). The default EE mask value is ff:ff:ff. NOTE: Only one mask per port can be set. When you set a mask, all existing end-to-end monitors are deleted. End-to-end masks are not supported on the following: • HP StorageWorks DC SAN Backbone Director • HP StorageWorks DC04 SAN Director Switch • HP StorageWorks 8/8 and 8/24 SAN Switches • HP StorageWorks 8/40 SAN Switch • HP StorageWorks 8/80 SAN Switch. On HP StorageWorks SAN Director 48 Port 4Gb FC blades, the upper 32 ports can be addressed only when the area ID and the AL_PA are used together. For usability concerns, the area ID and the AL_PA cannot be masked separately for any ports on HP StorageWorks SAN Director 48 Port 4Gb FC blades. 1. Connect to the switch and log in as admin. 2. Enter the perfSetPortEEMask command. perfsetporteemask [slotnumber/]portnumber "TxSIDMsk" "TxDIDMsk" "RxSIDMsk" "RxDIDMsk" where: slotnumber portnumber TxSIDMsk TxDIDMsk RxSIDMsk RxDIDMsk For bladed systems only, specifies the slot number of the port on which the mask is to be added. For all other switches, this operand is not required. Specifies the port number Specifies the transmitting source ID mask Specifies the transmitting destination ID mask Specifies the receiving source ID mask Specifies the receiving destination ID mask The perfSetPortEEMask command sets the mask for all end-to-end monitors of a port. If any end-to-end monitors are programmed on a port when the perfSetPortEEMask command is entered, a message is displayed similar to the following example: switch:admin> perfsetporteemask 1/2, "00:ff:ff" Changing EE mask for this port will cause ALL EE monitors on this port to be deleted. Continue? (yes, y, no, n): [no] y The EE mask on port 2 is set and EE monitors on this port are deleted The perfSetPortEEMask command sets a mask for the Domain ID, Area ID, and AL_PA of the SIDs and DIDs for frames transmitted from and received by the port. Figure 73 shows the mask positions in the command. A mask ("ff") is set on slot 1, port 2 to compare the AL_PA fields on the SID and DID in all frames (transmitted and received) on port 2. The frame SID and DID Fabric OS 6.2 administrator guide 409