HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2 administrator guide (5697-0 - Page 88

In the next example, on a Linux FreeRadius Server, the user takes the "operator" role, with ADList 1, 2, 4, 5, 6, 7, 8, 9, 12, 20 and HomeAD 2. user-opr Auth-Type := Local, User-Password == "password" Brocade-Auth-Role = "operator", Brocade-AVPairs1 = "ADList=1,2;HomeAD=2", Brocade-AVPairs2 = "ADList=-4-8,20;ADList=7,9,12" In the next example, on a Linux FreeRadius Server, the user takes the "zoneAdmin" role, with VFlist 2, 4, 5, 6, 7, 8, 10, 11, 12, 13, 15 17, 19, 22, 23, 24, 25, 29, 31 and HomeContext 1. user300 Auth-Type := Local, User-Password == "password" Brocade-Auth-Role = "zoneadmin", Brocade-AVPairs1 = "HomeContext=1;ContextRoleList=securityadmin:2,4-8,10" Brocade-AVPairs2 = "ContextRoleList=admin:11-13, 15, 17, 19;user:22-25,29,31" The RADIUS server NOTE: To set up the RADIUS server, you must know the switch IP address, in either IPv4 or IPv6 notation, or name to connect to switches. Use the ipAddrShow command to display a switch IP address. For Directors, the switch IP addresses are aliases of the physical Ethernet interfaces on the CP blades. When specifying client IP addresses for the Logical Switches in these systems, make sure the CP blade IP addresses are used. For accessing both the active and standby CP blade, and for the purpose of HA failover, both of the CP blade IP addresses must be included in the RADIUS server configuration. User accounts should be set up by their true network-wide identity, rather than by the account names created on a Fabric OS switch. Along with each account name, the administrator must assign appropriate switch access roles. To manage a fabric, these roles can be User, Admin, and SecurityAdmin. Configuring RADIUS server support with Linux The following procedures work for FreeRADIUS on Solaris and Red Hat Linux. FreeRADIUS is a freeware RADIUS server that you can find at the following web site: www.freeradius.org Follow the installation instructions at the web site. FreeRADIUS runs on Linux (all versions), FreeBSD, NetBSD, and Solaris. If you make a change to any of the files used in this configuration, you must stop the server and restart it for the changes to take effect. FreeRADIUS installation places the configuration files in $PREFIX/etc/raddb. By default, the PREFIX is /usr/local. Configuring RADIUS service on Linux consists of the following tasks: • Adding the Brocade attribute to the server • Creating the user • Enabling clients 88 Managing user accounts