HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2 administrator guide (5697-0 - Page 354

To create a TI zone and set the state to deactivated (failover is enabled by default): switch:admin> zone --create -t ti -o d bluezone -p "1,1; 2,4; 1,8; 2,6" To create a TI zone with failover disabled and the state set to deactivated: switch:admin> zone --create -t ti -o dn bluezone -p "1,1; 2,4; 1,8; 2,6" To create a TI zone in the edge fabric with failover enabled and the state set to activated (default settings): switch:admin> zone --create -t ti bluezone -p "1,1; 1,8; 2,-1; 3,-1" To create a TI zone in the backbone fabric with failover enabled and the state set to activated (default settings): switch:admin> zone --create -t ti backbonezone -p "10:00:00:04:1f:03:16:f2; 1,1; 1,4; 2,7; 2,1; 10:00:00:04:1f:03:18:f1, 10:00:00:04:1f:04:06:e2" To create TI zones in a Logical Fabric, such as the one shown in Figure 51 on page 348: Log in to the Logical Switch FID1, Domain 7 and create a TI zone in the Logical Fabric with FID=1: LS1> zone --create -t ti -o f "ti_zone1" -p "8,8; 8,1; 3,3; 3,10; 5,16; 5,8; 9,5; 9,9" Then create a TI zone in the base fabric, as described in "Creating a TI zone in a base fabric" on page 352. Remember that your changes are not enforced until you enter the cfgEnable command, as shown here: switch:admin> cfgenable "USA_cfg" You are about to enable a new zoning configuration. This action will replace the old zoning configuration with the current configuration selected. If the update includes changes to one or more traffic isolation zones, the update may result in localized disruption to traffic on ports associated with the traffic isolation zone changes Do you want to enable 'USA_cfg' configuration (yes, y, no, n): [no] y zone config "USA_cfg" is in effect Updating flash ... Creating a TI zone in a base fabric 1. Connect to the switch and log in as admin. 2. Create a dummy zone configuration in the base fabric. For example: zone --create "z1", "1,1" cfgcreate "base_config", z1 3. Enter the zone --create command to create the TI zone in the base fabric: zone --create -t objtype -o f name -p "portlist" where: objtype name portlist The zone object type, which is ti for TI zones. The name of the zone to be created. The list of ports to be included in the TI zone. Ports are designated using D,I (Domain,Index) format. Multiple ports are separated by a semicolon, followed by a space. The disable failover option is not supported in base fabrics. 352 Optimizing fabric behavior