HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2 administrator guide (5697-0 - Page 469

The following example shows the portShow fcipTunnel command used to display IPsec information for tunnel 3: switch:admin> portshow fciptunnel 8/ge0 3 -ipsec Port: ge0 Tunnel ID 3 Remote IP Addr 192.175.5.200 Local IP Addr 192.175.5.100 Remote WWN Not Configured Local WWN 10:00:00:05:1e:37:00:20 Compression off Fastwrite on Tape Pipelining on Uncommitted bandwidth, minimum of 1000 Kbps (0.001000 Gbps) SACK on Min Retransmit Time 100 Keepalive Timeout 80 Max Retransmissions 9 Status : Active Connected Count: 1 Uptime 1 hour, 16 minutes, 4 seconds IKE Policy 7 Authentication Algorithm: MD5 Encryption: 3DES Perfect Forward Secrecy: off Diffie-Hellman Group: 1 SA Life (seconds): 200000 IPSec Policy 7 Authentication Algorithm: AES-XCBC Encryption: 3DES SA Life (seconds): 1500000 Pre-Shared Key 1234567890123456 Virtual Fabrics and FCIP Any GigE_Port and all of its associated FCIP tunnels on a chassis can be assigned to any Logical Switch. As with the current Fabric OS, the port types supported by FCIP are either VE_ or VEX_Port. When a GigE port is moved to a Logical Switch, all eight VE_ and VEX_Ports are automatically moved. There is no interaction required to assign or move them. The following constraints on VE_ and VEX_Ports apply: • All VEX_Ports will be persistently disabled when Virtual Fabric mode is enabled. You need to create a Logical Switch with the base switch attribute turned on and move the ports to the new base switch. • The ports must be offline before they are moved from one Logical Switch to another. • A Logical Switch is independent of the base switch. Therefore all GigE_Port based protocol addresses, such as IP addresses, must be unique within a Logical Switch. • FCIP tunnels working as an extended ISL can carry traffic for multiple fabrics. Therefore a GigE_Port used as an extended ISL must be assigned to the base switch. TCP Byte Streaming TCP Byte Streaming allows an HP StorageWorks 400 Multi-Protocol Router or a B-Series Multi-Protocol Router Blade to communicate with supported third party WAN optimization hardware connected on the GigE ports configured for FCIP. This feature is enabled when configuring the FCIP tunnel. Fabric OS 6.2 administrator guide 465