HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2 administrator guide (5697-0 - Page 34

Displaying the network interface settings If an IP address has not been assigned to the network interface (Ethernet), you must connect to the Fabric OS CLI using a console session on the serial port. For more information, see "Console sessions using the serial port" on page 31. Otherwise, connect using SSH. 1. Connect to the switch and log in using an account assigned to the admin role. 2. Enter the ipAddrShow command. ecp:admin> ipaddrshow SWITCH Ethernet IP Address: 10.1.2.3 Ethernet Subnetmask: 255.255.240.0 CP0 Ethernet IP Address: 10.1.2.3 Ethernet Subnetmask: 255.255.240.0 Host Name: ecp0 Gateway IP Address: 10.1.2.1 CP1 Ethernet IP Address: 10.1.2.4 Ethernet Subnetmask: 255.255.240.0 Host Name: ecp1 Gateway IP Address: 10.1.2.3 IPFC address for virtual fabric ID 123: 11.1.2.3/24 IPFC address for virtual fabric ID 45: 13.1.2.4/20 Slot 7 eth0: 11.1.2.4/24 Gateway: 11.1.2.1 Backplane IP address of CP0 : 10.0.0.5 Backplane IP address of CP1 : 10.0.0.6 IPv6 Autoconfiguration Enabled: Yes Local IPv6 Addresses: sw 0 stateless fd00:60:69bc:70:260:69ff:fe00:2/64 preferred sw 0 stateless fec0:60:69bc:70:260:69ff:fe00:2/64 preferred cp 0 stateless fd00:60:69bc:70:260:69ff:fe00:197/64 preferred cp 0 stateless fec0:60:69bc:70:260:69ff:fe00:197/64 preferred cp 1 stateless fd00:60:69bc:70:260:69ff:fe00:196/64 preferred cp 1 stateless fec0:60:69bc:70:260:69ff:fe00:196/64 preferred IPv6 Gateways: cp 0 fe80:60:69bc:70::3 cp 0 fe80:60:69bc:70::2 cp 0 fe80:60:69bc:70::1 cp 1 fe80:60:69bc:70::3 If the Ethernet IP address, subnet mask, and gateway address are displayed, the network interface is configured. Verify that the information is correct. If DHCP is enabled, the network interface information was acquired from the DHCP server. You can use either IPv4 or IPv6 with a classless inter-domain routing (CIDR) block notation (also known as a network prefix length) to set up your IP addresses. 34